Keysight U8903B User Manual page 142

3 Audio Generator Functions
Table 3-28 Analog Generator > Output Config menu description (continued)
Menu Description
Press the IEC60268 10 Ω softkey to select the additional 10 Ω output series resistance for pin 2 or 3 of the XLR connector
in the common IEC60268 configuration. This setting is only available when the output connector type is set to IEC60268.
– Pin2
IEC60268 10 Ω
Additional 10 Ω is added to pin 2.
– Pin3
Additional 10 Ω is added to pin 3.
Press the Ground softkey to select the grounding type.
– Float
In the floating grounding type, the signal return line (XLR pin 1 for balanced output or BNC return for unbalanced
Ground output) is not grounded to the chassis earth and is "floating".
– Ground
In the ground grounding type, the signal return line (XLR pin 1 for balanced output or BNC return for unbalanced output)
is connected to the chassis earth.
Press the Max Vol tage softkey to set the maximum voltage. The maximum voltage value set will limit the maximum
Max Vol tage amplitude output from the generator and prevent any excessive high voltage values from damaging the device under
test (DUT).
142 Keysight U8903B User's Guide