Table A-24 Measurement Settings > Multitone Analyzer Menu Tree Description - Keysight U8903B User Manual

A Appendixes
Multitone analyzer
Table A-24 Measurement settings > Multitone Analyzer menu tree description
Tab Level 1
Output
Waveform Config
Multitone
(Signal Generation)
Tones Config
Multitone
Input Range
(Signal Analysis)
516
Level 2 Level 3
– Enable
Track 1st Ch
– Disable
Amplitude
Start Freq
Stop Freq
– Linear
Freq Spacing – Log
– Custom
Tone Count
– 1024
– 2048
– 4096
Length – 8192
– 16384
– 32768
– 65536
Apply
Optimize
Amplitude Dist – Zero
– Zero
Phase Dist
– Random
Frequency
Amplitude
Phase
Edit Tones Add Above
Add Below
Remove
Clear All
Active Channel
– Enable
Track 1st Ch
– Disable
Voltage Range
Description
Select the output channel.
Enable or disable the tracking of the first channel.
Set the total amplitude value.
Set the lowest frequency in the multitone
waveform.
Set the highest frequency in the multitone
waveform.
Select the frequency spacing between the tones.
Set the number of signal frequency components.
Select the waveform length value.
Apply the multitone after it has been customized.
Optimize the multitone.
Set the phase of all tones to 0 degrees.
Select the phase distribution of all tones in
degrees.
Set the frequency value.
Set the amplitude value.
Set the phase value.
Add a tone above the selected tone.
Add a tone below the selected tone.
Remove the selected tone.
Remove all the tones in the list.
Set the active channel for the absolute amplitude
for each tone to be displayed in a table.
Enable or disable the tracking of the first channel.
Set the input voltage range.
Keysight U8903B User's Guide