Notch Filter; Table 4-23 Analog Analyzer > Filter Config > Notch Filter Menu Description - Keysight U8903B User Manual

Notch Filter

Notch filter is used to remove the unwanted frequency component in the input signal. This
setting is only applicable for THD+N and SINAD measurements.
Figure 4-52
Table 4-23 Analog Analyzer > Filter Config > Notch Filter menu description
Menu Description
State Press the State softkey to enable or disable the notch filter.
Center Freq Press the Center Freq softkey to set the frequency of the component to be removed from the input signal.
Band wid th Press the Band wid th softkey to set the band width of the signal component to be removed.
Keysight U8903B User's Guide
Analog Analyzer > Filter Config > Notch Filter menu page
Audio Analyzer Measurement Functions 4
233