Table 7-52 Receiver Sensitivity > Signal Generation Settings Menu Description - Keysight U8903B User Manual

Signal generation
The receiver sensitivity signal generation settings menu page is displayed as shown in
Figure 7-54.
Figure 7-54
Table 7-52 Receiver Sensitivity > Signal Generation settings menu description
Menu Description
Press the Instrument softkey to select the signal generator model.
Instrument – Keysight E4438C
– Other
GPIB address Press the GPIB address softkey to set the GPIB address for the connected signal generator.
Start Power Press the Start Power softkey to set the sweep start RF power.
Stop Power Press the Stop Power softkey to set the sweep stop RF power.
Step Size Press the Step Size softkey to set the step size.
Dwell Time Press the Dwell Time softkey to set the delay between each measured SINAD in seconds.
Press the Init Instrument softkey to enable or disable the U8903B to send SCPI commands to initialize the connected
Init Instrument
signal generator.
Press the FM Frequency softkey to set the RF signal output frequency. This setting is only available if Instrument is set to
FM Frequency
Keysight E4438C and the Init Instrument is enabled.
Press the FM Deviation softkey to set the RF signal frequency modulation deviation. This setting is only available if
FM Deviation
Instrument is set to Keysight E4438C and the Init Instrument is enabled.
Press the FM Rate softkey to set the RF signal internal frequency modulation rate. This setting is only available if
FM Rate
Instrument is set to Keysight E4438C and the Init Instrument is enabled.
Keysight U8903B User's Guide
Receiver Sensitivity > Signal Generation settings menu page
Test Sequence Application 7
381