Table 7-21 Phase > Signal Analysis Settings Menu Description - Keysight U8903B User Manual

Signal analysis
The phase signal analysis settings menu page is displayed as shown in Figure 7-22.
Figure 7-22
Table 7-21 Phase > Signal Analysis settings menu description
Menu Description
Press the Ref Channel softkey to set the reference channel number. The phase of each channel is measured against the
Ref Channel
reference channel. The phase result for the reference channel should always be displayed zero.
Press the Sample Size softkey to select the number of samples to be acquired for the measurement.
– 2048
– 4096
– 8192
– 16384
– 32768
Sample Size
– 65536
– 131072
– 262144
– 524288
– 1M
– 2M
Press the Input Range softkey to configure the input range settings.
– Track 1st Ch
If Track 1st Ch is enabled, all the other channels will be set to follow the channel 1 range setting. Any changes made to
Input Range channel 1 range setting will be reproduced in the other channels. Disable the Track 1st Ch to set the individual
channels.
– Voltage Range
Set the input voltage range.
Keysight U8903B User's Guide
Phase > Signal Analysis settings menu page
Test Sequence Application 7
321