Keysight U8903B User Manual page 361

Table 7-43 External Frequency Sweep > Signal Analysis settings menu description (continued)
Menu Description
Press the HPF softkey to select the high-pass filter.
– None
– 15 Hz
– 20 Hz
– 22 Hz
– 30 Hz
HPF – 50 Hz
– 70 Hz
– 100 Hz
– 200 Hz
– 300 Hz
– 400 Hz
– Custom
Press the Weighting softkey to select the weighting filter.
– None
– A
– CCIR 1k
Weighting
– CCIR 2k
– CCITT
– C-Message
– Custom
Press the Deemphasis softkey to select the de-emphasis filter.
– None
Deemphasis – 50 μs
– 75 μs
– Custom
Press the Notch Fil ter softkey to configure the notch filter settings.
– HP8903B
Enable or disable the HP8903B mode.
– Custom Notch
Notch Filter Enable or disable the custom notch.
– Center Freq
Set the center frequency value. This is only applicable when custom notch is enabled.
– Band width
Set the bandwidth value. This is only applicable when custom notch is enabled.
Keysight U8903B User's Guide
Test Sequence Application 7
361