Edit Points; Table 6-7 Sweep > Edit Points Menu Description - Keysight U8903B User Manual

Edit Points

Figure 6-8
Table 6-7 Sweep > Edit Points menu description
Menu Description
Press the Data Channel softkey to select the trace data channel number to be plotted.
Data Channel
This setting is only available when the measured channels are more than one channel.
Press the Wrap Phase softkey to enable or disable the wrap phase. This is only applicable if Y Data or Y2 Data is set to
phase.
– On
Wrap Phase
The phase result is wrapped so that it falls within the range of -180° ~ 180°.
– Off
The result displayed is the exact value after substracted from the reference channel.
Press the Goto Point softkey to set the sweep point number to go to. The sweep point number will be highlighted. You can
Goto Point
also use the arrow keys to select the desired sweep point.
Point Value Press the Point Value softkey to set the currently selected sweep point value.
Add Point Press the Add Point softkey to add a sweep point.
Remove Point Press the Remove Point softkey to remove the selected sweep point.
Press the Load Points softkey to load the sweep points from a file.
Load Points
Refer to "Recall" on page
Press the Save Points softkey to save the sweep points to a file.
Save Points
Refer to "Save" on page
If the sweep points are changed, the sweep spacing mode will be set to Custom. Refer to
NOTE
Table 6-2 for more information.
Keysight U8903B User's Guide
Sweep > Edit Points menu page 1
95 for the Recall menu page.
94 for the Save menu page.
Sweep Function 6
289