Appendix 11: Sweep Function Menu Tree; Table A-11 Sweep Function Menu Tree Description - Keysight U8903B User Manual

A Appendixes

Appendix 11: Sweep Function Menu Tree

Table A-11 Sweep function menu tree description
Level 1 Level 2
– Sweep
App.Type
– Group Delay
Parameter
Spacing
Unit
Start
Points Settings
Stop
Step
Points
Edit Points
Dwell Time
Continuous
Sweep Mode
Single
Source
Channels
Measure
490
Level 3 Level 4
– Log
– Linear
– Custom
– Vrms
– dBV
– Vp
– Vpp
– dBm
– dBu
– dBSPL
1 to 2
1 to 8
Description
Select the sweep application type.
This is only available when the sweep application
type is Sweep.
Select the sweep parameter type.
The parameter selection depends on the
waveform type set at the analog generator.
Select the spacing type.
Select the sweep unit.
This setting is only available when the sweep
parameter is amplitude.
Set the sweep start value. This setting is only
available when the sweep spacing is Log or
Linear.
Set the sweep stop value. This setting is only
available when the sweep spacing is Log or
Linear.
Set the sweep step value. This setting is only
available when the sweep spacing is Log or
Linear.
Set the sweep points value. This setting is only
available when the sweep spacing is Log or
Linear.
Refer to "Ed it points" on page 492
points menu tree.
Set the delay in ms for the generator to output the
signal.
Select the sweep mode.
Select the source channel(s).
Select the measure channel(s).
The available selection depends on the number of
installed analog analyzer cards.
Keysight U8903B User's Guide
for the edit