Table 7-8 Tsa > Project > Test > Io Configuration > Input Configuration Menu Description (Analog) - Keysight U8903B User Manual

7 Test Sequence Application
Input configuration (Analog)
The TSA > Project > Test > IO Configuration > Input Configuration menu page is displayed
as shown in Figure 7-9.
Figure 7-9
Table 7-8 TSA > Project > Test > IO Configuration > Input Configuration menu description (Analog)
Menu Description
Channels Press the Channels softkey to select the number of input channels in use.
Press the Connector softkey to select the input connector type.
– UnBal
Unbalanced connector type routes the signal from the BNC input connector. The signal in the inner conductor of the
coaxial connector is referenced to the ground for measurement.
– Bal
Balanced connector type routes the signal from the XLR input connectors in the front panel to the analog analyzer. The
signals on the positive and negative pins of the XLR connector enter a differential amplifier where they are subtracted
Connector
before passing on to the detector.
– Loopback
Loopback connector type routes the signal from the generator to the analyzer internally.
The generator channel 1 signal will be routed to the analyzer odd channels (1, 3, 5, and 7), and the generator channel 2
signal will be routed to the analyzer even channels (2, 4, 6, and 8).
For example, if you select Loopback in any of the analyzer odd channels, the output connector type of the generator
channel 1 will automatically be set to Loopback.
Press the Impedance softkey to select the input impedance value. This setting is only available when Connector is set to
UnBal or Bal.
– 100 kΩ (for Unbalanced)
Impedance
– 200 kΩ (for Balanced)
– 600 Ω
– 300 Ω
302
TSA > Project > Test > IO Configuration > Input Configuration menu page (Analog)
Keysight U8903B User's Guide