Axis Settings; Table 5-3 Graph Analysis > Axis Settings Menu Description - Keysight U8903B User Manual

5 Graph Analysis

Axis Settings

The axis settings for graph analysis is displayed as shown in Figure 5-3.
Figure 5-3
Table 5-3 Graph Analysis > Axis Settings menu description
Menu Description
Press the Axis softkey to select the active axis to be configured.
Axis – Primary
– Secondary
Press the Enabled softkey to enable or disable the axis settings. This setting is only available when the axis type is
Enabled
secondary. If the axis type is primary, this setting is always set to On.
Press the Left softkey to set the left axis limit value. If the value entered is more than the right value, the right value will
Left
automatically be set to a value of (Left + 10).
Press the Right softkey to set the right axis limit value. If the value entered is more than the left value, the left value will
Right
automatically be set to a value of (Right – 10).
Span Press the Span softkey to set the total X-axis span or total range to be monitored in the graph.
Center Press the Center softkey to set the X-axis center point in the graph.
Press the Top softkey to set the top axis limit value. If the value entered is less than the bottom value, the bottom value will
Top
automatically be set to a value of (Top – 10).
Press the Bottom softkey to set the bottom axis limit value. If the value entered is more than the top value, the top value
Bottom
will automatically be set to a value of (Bottom + 10).
264
Graph Analysis > Axis Settings menu page 1
Keysight U8903B User's Guide