Table 7-17 Tsa > Project > Test > Ac Level > Settings > Signal Analysis Menu - Keysight U8903B User Manual

Table 7-17 TSA > Project > Test > AC Level > Settings > Signal Analysis menu description
Menu Description
Press the Detector softkey to select the AC level detector type.
– RMS
Detector AC level measurement is expressed in an rms value.
– Pk-Pk
AC level measurement is expressed in a Vpp value.
Press the LPF softkey to select the low-pass filter.
– None
– 2 kHz
– 3 kHz
– 5 kHz
– 8 kHz
– 10 kHz
LPF – 15 kHz
– 20 kHz
– 22 kHz
– 30 kHz
– 40 kHz
– 50 kHz
– 80 kHz
– Custom
Press the Sample Size softkey to select the number of samples to be acquired for the measurement.
– 2048
– 4096
– 8192
– 16384
– 32768
Sample Size
– 65536
– 131072
– 262144
– 524288
– 1M
– 2M
Press the Input Range softkey to configure the input range settings.
– Auto Range
Enable or disable the auto input range.
If auto range is enabled, each analog channel input range is determined automatically, based on the level of the input
signal. If the input signal level changes beyond the ranging threshold, auto range will cause the input ranging circuits to
move up or down for a proper ranging.
If auto range is disabled, you can set a fixed input voltage range for each analog input channel.
Input Range
– Track 1st Ch
If Track 1st Ch is enabled, all the other channels will be set to follow the channel 1 range setting. Any changes made to
channel 1 range setting will be reproduced in the other channels. Disable the Track 1st Ch to set the individual
channels.
– Voltage Range
Set the input voltage range.
Keysight U8903B User's Guide
Test Sequence Application 7
315