Keysight U8903B User Manual page 288

6 Sweep Function
Table 6-6 Sweep > Plot View > Plot Settings menu description (continued)
Menu Description
Press the Wrap Phase softkey to enable or disable the wrap phase. This is only applicable if Y Data or Y2 Data is set to
phase.
– On
Wrap Phase
The phase result is wrapped so that it falls within the range of -180° ~ 180°.
– Off
The result displayed is the exact value after substracted from the reference channel.
Press the Hold Type softkey to select the data type to be plotted in the graph.
– None
Initial sweep data.
– Average
Hold Type Each point is averaged with the corresponding point from the previous result.
– Max
Always keep the maximum value of each point.
– Min
Always plot the minimum value of each point.
288 Keysight U8903B User's Guide