Keysight U8903B User Manual page 429

Table A-4 Analog generator menu tree description (continued)
Level 1 Level 2
Amplitude
Lower Freq
Upper Freq
Waveform Config
(SMPTE 1:1/4:1/10:1)
DC Offset
Summation
Amplitude
Upper Freq
Diff Freq
Waveform Config
(IEC 60118)
DC Offset
Summation
Amplitude
Center Freq
Diff Freq
Waveform Config
(IEC 60268)
DC Offset
Summation
Amplitude
Waveform Config
(Gaus. Noise)
DC Offset
Amplitude
Waveform Config
(Rect. Noise)
DC Offset
Amplitude
Waveform Config
(Pink Noise)
DC Offset
Amplitude
Waveform Config
(Square)
Frequency
Waveform Config
Voltage
(DC)
Amplitude
Frequency
DC Offset
Waveform Config
Burst On
(Sine Burst)
Period
Low Level
Keysight U8903B User's Guide
Level 3 Description
Set the signal amplitude value.
Set the lower frequency value.
Set the higher frequency value.
Set the signal DC offset value.
– RSS
Summation refers to the method to sum up two levels.
– Linear
Set the signal amplitude value.
Set the higher frequency value.
Set the difference frequency of the waveform.
Set the signal DC offset value.
– RSS
Summation refers to the method to sum up two levels.
– Linear
Set the signal amplitude value.
Set the center frequency of the waveform.
Set the difference frequency of the waveform.
Set the signal DC offset value.
– RSS
Summation refers to the method to sum up two levels.
– Linear
Set the signal amplitude value.
Set the signal DC offset value.
Set the signal amplitude value.
Set the signal DC offset value.
Set the signal amplitude value.
Set the signal DC offset value.
Set the signal amplitude value.
Set the signal frequency value.
Set the signal voltage value.
Set the signal amplitude value.
Set the signal frequency value.
Set the signal DC offset value.
Set the number of cycles at which the amplitude is at the highest level.
Set the number of cycles from the beginning of one burst to the beginning
of the next burst.
Set the amplitude ratio of Burst On over Burst Off.
Appendixes A
429