Table 7-50 Dc Level Sweep > Signal Generation Settings Menu Description - Keysight U8903B User Manual

Table 7-50 DC Level Sweep > Signal Generation settings menu description
Menu Description
Output Press the Output softkey to select the output channel.
Press the Sweep Config softkey to set the sweep configuration.
– Start
Set the start value for the sweep parameter.
– Stop
Set the stop value for the sweep parameter.
– Spacing
Select Log, Linear, or Custom for the sweep spacing.
Sweep Config
– Points
Set the number of sweep points.
– Step Size
Set the step size for linear spacing. This setting is only available when spacing is set to Linear.
– Dwell Time
Set the delay between the sweep points.
– Edit Points
Edit the individual points value, insert or remove points, load points, and save the points.
Signal analysis
The DC level sweep signal analysis settings menu page is displayed as shown in
Figure 7-52.
Figure 7-52
Keysight U8903B User's Guide
DC Level Sweep > Signal Analysis settings menu page
Test Sequence Application 7
377