Appendix 22: U8903B Configuration Examples; Example 1: Generating A Sine Waveform With The Digital Generator And Measuring Its Voltage With The Digital Analyzer - Keysight U8903B User Manual

Appendix 22: U8903B Configuration Examples

Example 1: Generating a sine waveform with the digital generator and
measuring its voltage with the digital analyzer
In this example, you will learn how to generate a simple sine waveform from the U8903B
digital generator and measure its voltage using the U8903B digital analyzer.
To generate a sine waveform from the digital unbalanced output with a frequency of 1 kHz
and amplitude of 1 FFS, perform the following steps.
1 Connect the digital generator unbalanced output to the digital analyzer unbalanced
input channel in the rear panel using a BNC cable.
2 Press
3 Press Waveform, and select Sine as the waveform type.
4 Press Output Config > Connector, and select Unbalanced as the digital generator output
type.
5 Press Output Config > AES Output, and enable the AES output.
6 Press Waveform Config > Frequency, and set the frequency to 1 kHz.
7 Press Waveform Config > Amplitude, and set the amplitude to 1 FFS.
8 Press
9 After you have completed the steps above, the U8903B display should look as follows.
Figure A-9
Keysight U8903B User's Guide
on the FUNCTION panel to switch to audio generator mode, and press
on the FUNCTION panel to switch to digital interface.
to start the signal generation on the digital generator channel 1.
Digital generator sine waveform generation
Appendixes A
571