Table 7-7 Tsa > Project > Test > Io Configuration > Output Configuration Menu Description (Bluetooth) - Keysight U8903B User Manual

Output configuration (Bluetooth)
The TSA > Project > Test > IO Configuration > Output Configuration menu page is displayed
as shown in Figure 7-8.
Figure 7-8
Table 7-7 TSA > Project > Test > IO Configuration > Output Configuration menu description (Bluetooth)
Menu Description
Press the Channels softkey to select the number of output channels in use.
– None (External)
Disable the generator outputs and configure the analyzer for external source (open-loop) measurements.
Channels
– 1
This is only applicable if the Profiles consist of only HFP, or HFP and AVRCP.
– 2
This is only applicable if the Profiles consist of A2DP.
Device Press the Device softkey to select the paired or connected Bluetooth device.
Press the Profiles softkey to select the profile that will be used in the test. If the connected Bluetooth device is selected in
Device, the profile used will be fixed to the connected profile(s).
– A2DP
Profiles
– HFP
– AVRCP
Press the Link Config softkey to configure the Bluetooth link settings. Refer to "Link Configuration (Bluetooth
Link Config
Generator)" on page 146.
Press the Reference softkey to set the output references for generator.
References
– Volt/FS
Set the volts/FS reference value.
Keysight U8903B User's Guide
TSA > Project > Test > IO Configuration > Output Configuration menu page (Bluetooth)
Test Sequence Application 7
301