Keysight U8903B User Manual page 434

A Appendixes
Table A-5 Digital generator menu tree description (continued)
Level 1 Level 2
Amplitude
Waveform Config
Frequency
(Square)
DC Offset
Amplitude
Frequency
Waveform Config Burst On
(Sine Burst)
Period
Low Level
Amplitude
Waveform Config
Frequency
(Stereo)
DC Offset
Waveform Config
Samples/Step
(Monotonicity)
Waveform Config
Voltage
(Constant)
Waveform Config
Samples/Step
(Walking Zero)
Waveform Config
Samples/Step
(Walking One)
Amplitude
Start Freq
Stop Freq
Freq Spacing
Waveform Config
(Multitone)
Tones
Length
434
Level 3 Level 4
– Linear
– Log
– Custom
– 1024
– 2048
– 4096
– 8192
– 16384
– 32768
– 65536
Description
Set the signal amplitude value.
Set the signal frequency value.
Set the signal DC offset value.
Set the signal amplitude value.
Set the signal frequency value.
Set the number of cycles at which the signal
amplitude will be at the higher level.
Set the number of cycles from the beginning of
one burst to the beginning of the next burst.
Set the amplitude ratio of Burst On over Burst Off.
Set the signal amplitude value.
Set the signal frequency value.
Set the signal DC offset value.
Set the duration for each half cycle of the square
wave.
Set the signal voltage value.
Set the speed the single bit 0 is incremented.
Set the speed the single bit 1 is incremented.
Set the signal amplitude value.
Set the lowest frequency in the multitone
waveform which is usually the frequency for the
first tone.
Set the highest frequency in the multitone
waveform which is usually the frequency for the
last tone.
Select frequency spacing between the tones.
Custom is selected when the custom multitone
waveform is set.
Set the number of signal frequency components.
Select the waveform length that determines the
number of samples used to create one iteration of
the multitone waveform.
Keysight U8903B User's Guide