Properties; Table 7-15 Tsa > Project > Test > Measurement > Properties Menu Description - Keysight U8903B User Manual

7 Test Sequence Application

Properties

An example of the measurement properties menu page is displayed as shown in
Figure 7-16.
Figure 7-16
Table 7-15 TSA > Project > Test > Measurement > Properties menu description
Menu Description
Name Press the Name softkey to rename the selected measurement.
Press the Sub-Steps softkey to configure the sub-steps settings. Refer to "Sub-steps" on page
Sub-Steps
on the sub-steps settings.
Press the Failure Handling softkey to select the failure handling type for the selected measurement. When a measurement
exceeded its preset limit or faced failure due to improper configuration (for example, calling for a file that does not exist or
sending a SCPI sub-step to an unconnected devices), you can direct the application to the following:
– Cancel Seq.
Stop the test sequence.
Failure Handling
– Allow Retry
Display a prompt window with Abort, Retry, and Ignore commands. Abort will immediately stop the test sequence. Retry
will rerun the selected measurements. Ignore will flag the measurement as failed and continue with the test sequence.
– Continue Seq.
Flag the measurement as failed and continue with the test sequence.
312
TSA > Project > Test > AC Level > Properties menu page
307 for more information
Keysight U8903B User's Guide