Table A-28 Measurement Settings > External Frequency Sweep Menu Tree Description - Keysight U8903B User Manual

External frequency sweep
Table A-28 Measurement settings > External Frequency Sweep menu tree description
Tab Level 1
Instrument
GPIB Address
Init Instrument
Init SCPI
Sweep SCPI
External Frequency
Sweep
(Signal Generation)
Sweep Config
Keysight U8903B User's Guide
Level 2 Level 3
– Keysight 33220A
– Keysight 33250A
– Keysight 33500A
– Keysight 33600A
– Other
– 0 to 30
– On
– Off
– Edit
– Import
– Edit
– Import
Start
Stop
Spacing
Points
Step Size
Dwell Time
Point No
Point Value
Insert Point Above
Insert Point Below
Remove Point
Clear
Edit Points
Reverse Order
Sort
Load Points
Save Points
Appendixes
Description
Select the instrument model.
Select the GPIB address.
Enable or disable the U8903B to send SCPI
commands to initialize the connected
signal generator.
Set the SCPI commands that initialize the
connected instrument. You can set the SCPI
command directly or load from a file.
Set the sweep SCPI commands that initialize the
connected instrument. You can set the SCPI
command directly or load from a file.
Set the start value for the sweep parameter.
Set the stop value for the sweep parameter.
Select Log, Linear, or Custom for the sweep
spacing.
Set the number of sweep points.
Set the step size for linear spacing. This setting is
only available when spacing is set to Linear.
Set the delay between the sweep points.
Set the point number.
Set the point value.
Insert a point above the selected point.
Insert a point below the selected point.
Remove the selected point.
Clear all points.
Reverse the order of the points.
Sort the points in ascending order.
Load points from a file.
Refer to "Append ix 13: Recall Menu Tree" on
page 494 for the recall menu tree.
Save the points to a file.
Refer to "Append ix 12: Save Menu Tree" on
page 493 for the save menu tree.
A
525