Table A-29 Measurement Settings > Stepped Level Sweep Menu Tree Description - Keysight U8903B User Manual

A Appendixes
Stepped level sweep
Table A-29 Measurement settings > Stepped Level Sweep menu tree description
Tab Level 1
Waveform
Output
Sweep Config
Stepped Level Sweep
(Signal Generation)
Sweep Config
Waveform Config
528
Level 2 Level 3
– Sine
– Arbitrary
Start
Stop
Spacing
Points
Step Size
Dwell Time
Point No
Point Value
Insert Point Above
Insert Point Below
Remove Point
Edit Points
Clear
Reverse Order
Sort
Load Points
Edit Points Save Points
– Enable
Track 1st Ch
– Disable
Frequency
DC Offset
Description
Select the waveform type.
Select the output channel.
Set the start value for the sweep parameter.
Set the stop value for the sweep parameter.
Select Log, Linear, or Custom for the sweep
spacing.
Set the number of sweep points.
Set the step size for linear spacing. This setting is
only available when spacing is set to Linear.
Set the delay between the sweep points.
Set the point number.
Set the point value.
Insert a point above the selected point.
Insert a point below the selected point.
Remove the selected point.
Clear all points.
Reverse the order of the points.
Sort the points in ascending order.
Load points from a file.
Refer to "Append ix 13: Recall Menu Tree" on
page 494 for the recall menu tree.
Save the points to a file.
Refer to "Append ix 12: Save Menu Tree" on
page 493 for the save menu tree.
Enable or disable the tracking of the first channel.
Set the frequency value.
Set the DC offset value.
Keysight U8903B User's Guide