Keysight U8903B User Manual page 386

7 Test Sequence Application
Table 7-54 External Level Sweep > Signal Generation settings menu description (continued)
Menu Description
Press the Sweep SCPI softkey to set the sweep SCPI commands that initialize the connected instrument. You can set the
SCPI command directly or load from a file.
Sweep SCPI
– Edit
– Import (Refer to "Recall" on page
Press the Sweep Config softkey to set the sweep configuration.
– Start
Set the start value for the sweep parameter.
– Stop
Set the stop value for the sweep parameter.
– Spacing
Select Log, Linear, or Custom for the sweep spacing.
Sweep Config
– Points
Set the number of sweep points.
– Step Size
Set the step size for linear spacing. This setting is only available when spacing is set to Linear.
– Dwell Time
Set the delay between the sweep points.
– Edit Points
Edit the individual points value, insert or remove points, load points, and save the points.
386
95 for more information on the Recall menu page.)
Keysight U8903B User's Guide