Measurement; Table 8-2 Hp8903B > Measurement Menu Description - Keysight U8903B User Manual

8 HP8903B

Measurement

Select Measurement in the HP8903B menu page to configure the HP8903B measurement
settings.
Figure 8-2
Table 8-2 HP8903B > Measurement menu description
Menu Description
Press the Function softkey to select the HP8903B measurement mode.
– AC LEVEL
– SINAD
Function – DISTN
– DC LEVEL
– SIG / NOISE
– DISTN LEVEL
Press the LP Fil ter softkey to select the HP8903B measurement low-pass filter value. The default low-pass filter can be
set at "HP8903B Config" on page 89.
– None
LP Fil ter
– 30 kHz
– 80 kHz
Press the HP/W Filter softkey to select the HP8903B high-pass or weighting filter value. The filter selection depends on
HP/W Fil ter
the left and right filters set at "HP8903B Config" on page 89.
Press the Reference softkey to set the reference value to be compared with the measured value in ratio mode. Changing
Reference
the reference value will enable the measurement ratio mode.
Ratio Press the Ratio softkey to enable or disable the HP8903B measurement ratio mode.
Press the Format softkey to select the HP8903B measurement format type.
Format – Log
– Lin
410
HP8903B > Measurement menu page
Keysight U8903B User's Guide