Sweep Type And Frequency - Keysight N9923A User Manual

Frequency Offset Using Power Sensor (FOPS) – Option 208
FOPS Settings
—
—

Sweep Type and Frequency

Set the source and receiver frequencies for the FOPS measurements. The
receiver is a Keysight U-Series Power Sensor. These are broadband
measurement devices, which means that they measure power over a very wide
frequency range. Tables of frequency and power correction factors are stored
within the power sensors. The receiver (Rx) frequencies are used ONLY to apply
the appropriate correction factors to the power levels measured with the power
sensor.
It is YOUR responsibility to ensure that ONLY the signal of interest is
present at the power sensor. All other signals MUST be filtered
appropriately.
How to set Sweep Type and Frequency
— Press Freq/Dist
— Then
— Then choose from the following:
—
To make FOPS measurements at a single frequency, choose Swept, then
enter a Src Center frequency, then Span = 0 Hz.
—
140
Gain
Not available until source data is stored into memory. Displays the
Output power / Source power (memory trace).
Rx Power
Displays the raw received power at the USB power sensor.
Sweep Type
CW
Used to make standard (non-offset) power meter measurements at a
single frequency. Learn more in
Swept Used to make swept FOPS measurements.
—— Then enter source (Src) frequencies as either Center and Span
or Start and Stop. Both methods set the FieldFox internal
source sweep range out the Port 1 RF Output connector.
——The frequency limits are determined by the limits of both the
FieldFox and the power sensor.
——The LOW frequency is limited by the higher of either the
FieldFox or the power sensor minimum frequencies.
——The HIGH frequency is limited by the lower of either the
FieldFox or the power sensor maximum frequencies.
——Then More.
Freq
——Then
frequencies below the graticules are displayed. Choose from
the following:
"USB Power Meter Settings" on page
Display. This determines how the receiver
Keysight N9923-90001 User's Guide
128.