2
General Power Meter Functions
Frequency sweep mode
Frequency sweep is generally used in a frequency response calibration system
where the amplitude is fixed, and the frequency of the power source signal is
swept. This mode can be used to determine the frequency response of a device
under test.
This feature is only available when N8480 Series, E-Series E4410, E-Series
NOTE
E9300, E-Series E9320 or P-Series N1920 sensor is connected.
Procedures
1 Connect sensor to a power source.
2 Connect power meter TRIG OUT to power source TRIG IN using a BNC cable.
3 Press
When N8480 Series, E-Series E4410 or E-Series E9300 sensor is connected,
NOTE
Sensor Mode is set to AVG only by default.
112
The same connection is applied for power source TRIG OUT to power meter
TRIG IN. See
Figure
. The Channel Setup displays as shown in
2-43.
Figure
Keysight N1911A/1912A User's Guide
2-44.