Flash Memory Control Register 2 (Flmcr2) - Renesas H8/38024 Hardware Manual

Bit 0—Program (P)
This bit is to set changing to or cancelling program mode (do not set SWE, ESU, PSU, EV, PV,
and E bits at the same time).
Bit 0
P Description
0 Program mode is cancelled
1 When this bit is set to 1, while the SWE = 1 and PSU = 1, the flash memory
changes to program mode.
6.6.2

Flash Memory Control Register 2 (FLMCR2)

Bit 7
FLER
Initial value 0
Read/Write R
FLMCR2 is a register that displays the state of flash memory programming/erasing. FLMCR2 is a
read-only register, and should not be written to.
Bit 7—Flash Memory Error (FLER)
This bit is set when the flash memory detects an error and goes to the error-protection state during
programming or erasing to the flash memory. See section 6.9.3, Error Protection, for details.
Bit 7
FLER Description
0 The flash memory operates normally.
1 Indicates that an error has occurred during an operation on flash memory
(programming or erasing).
Bits 6 to 0—Reserved
These bits are always read as 0 and cannot be modified.
Rev. 6.00, 08/04, page 158 of 628
6 5
— —
0 0
— —
4 3
— — —
0 0
— — —
(initial value)
2 1
— —
0 0
— —
(initial value)
0
0