Renesas H8/38024 Hardware Manual page 151

Bits 6 to 4—Standby Timer Select 2 to 0 (STS2 to STS0)
These bits designate the time the CPU and peripheral modules wait for stable clock operation after
exiting from standby mode or watch mode to active mode due to an interrupt. The designation
should be made according to the operating frequency so that the waiting time is at least equal to
the oscillation stabilization time. Note that stabilization times for the H8/38024, H8/38024S, and
H8/38024F-ZTAT Group and for the H8/38124 Group are different.
• H8/38024, H8/38024S, H8/38024F-ZTAT Group
Bit 6 Bit 5
STS2 STS1
0 0
0 0
0 1
0 1
1 0
1 0
1 1
1 1
• H8/38124 Group
Bit 6 Bit 5
STS2 STS1
0 0
0 0
0 1
0 1
1 0
1 0
1 1
1 1
Note: Unit for times is ms.
If an external clock is being input, set standby timer select to external clock mode before
mode transition. Also, do not set standby timer select to external clock mode if no external
clock is used. 8,192 states (STS2 = STS1 = STS0 = 0) is recommended if the on-chip
oscillator is used on the H8/38124 Group.
Bit 4
STS0 Description
0 Wait time = 8,192 states
1 Wait time = 16,384 states
0 Wait time = 1,024 states
1 Wait time = 2,048 states
0 Wait time = 4,096 states
1 Wait time = 2 states
0 Wait time = 8 states
1 Wait time = 16 states
Bit 4
STS0 Description
0 Wait time = 8,192 states
1 Wait time = 16,384 states
0 Wait time = 32,768 states
1 Wait time = 65,536 states
0 Wait time = 131,072 states
1 Wait time = 2 states
0 Wait time = 8 states
1 Wait time = 16 states
(initial value)
(External clock input mode)
(initial value)
(External clock input mode)
Rev. 6.00, 08/04, page 121 of 628