Renesas H8/38024 Hardware Manual page 277

Bits 6 and 5—Counter Up/Down Control (TMC6, TMC5)
Selects whether TCC up/down control is performed by hardware using UD pin input, or whether
TCC functions as an up-counter or a down-counter.
Bit 6 Bit 5
TMC6 TMC5
0 0
0 1
1
*
Bits 4 and 3—Reserved
Bits 4 and 3 are reserved; they are always read as 1 and cannot be modified.
Bits 2 to 0—Clock Select (TMC2 to TMC0)
Bits 2 to 0 select the clock input to TCC. For external event counting, either the rising or falling
edge can be selected.
Bit 2 Bit 1
TMC2 TMC1
0 0
0 0
0 1
0 1
1 0
1 0
1 1
1 1
Note: * The edge of the external event signal is selected by bit IEG1 in the IRQ edge select
register (IEGR). See IRQ Edge Select Register (IEGR) in section 3.3.2 for details. IRQ1
in port mode register B (PMRB) must be set to 1 before setting 111 in bits TMC2 to TMC0.
Description
TCC is an up-counter
TCC is a down-counter
Hardware control by UD pin input
UD pin input high: Down-counter
UD pin input low: Up-counter
Bit 0
TMC0 Description
Internal clock: φ/8192
0
Internal clock: φ/2048
1
Internal clock: φ/512
0
Internal clock: φ/64
1
Internal clock: φ/16
0
Internal clock: φ/4
1
Internal clock: φ
0
External event (TMIC): rising or falling edge *
1
/4
W
Rev. 6.00, 08/04, page 247 of 628
(initial value)
*: Don't care
(initial value)