Note On Use Of Hd64F38024; Notes On H8/38124 Group - Renesas H8/38024 Hardware Manual

Note: * This figure applies to the H8/38024, H8/38024S, and H8/38024F-ZTAT Groups. The
number of states on the H8/38124 Group is 8,192 or more.
4.5.3

Note on Use of HD64F38024

When using the HD64F38024, the oscillators may not operate if an initial voltage of 10 mV is
applied to the V pin during power-on. This problem is caused by uncertainty about the state of
CC
the oscillation control signals. It can be corrected by cutting off power and allowing the V
voltage to drop to ground potential before powering-on once again.
4.6

Notes on H8/38124 Group

When using the on-chip emulator, system clock precision is necessary for programming or erasing
the flash memory. However, the on-chip oscillator frequency can vary due to changes in
conditions such as voltage or temperature. Consequently, when using the on-chip emulator, pins
OSC1 and OSC2 should be connected to an oscillator, or an external clock should be supplied, if
the on-chip oscillator is selected. In this case, the LSI uses the on-chip oscillator when user
programs are being executed and the system clock oscillator when programming or erasing flash
memory. The process is controlled by the on-chip emulator.
Rev. 6.00, 08/04, page 116 of 628
pin
CC