Table of Contents
Advertisement
5.7
Active (Medium-Speed) Mode
5.7.1
Transition to Active (Medium-Speed) Mode
If the MSON bit in SYSCR2 is set to 1 while the LSON bit in SYSCR1 is cleared to 0, a transition
to active (medium-speed) mode results from IRQ
mode, timer A, timer F, timer G, IRQ
interrupt in sleep mode. A transition to active (medium-speed) mode does not take place if the I
bit of CCR is set to 1 or the particular interrupt is disabled in the interrupt enable register.
Furthermore, it sometimes acts with half state early timing at the time of transition to active
(medium-speed) mode.
5.7.2
Clearing Active (Medium-Speed) Mode
Active (medium-speed) mode is cleared by a SLEEP instruction.
• Clearing by SLEEP instruction
A transition to standby mode takes place if the SLEEP instruction is executed while the SSBY
bit in SYSCR1 is set to 1, the LSON bit in SYSCR1 is cleared to 0, and the TMA3 bit in TMA
is cleared to 0. The system goes to watch mode if the SSBY bit in SYSCR1 is set to 1 and bit
TMA3 in TMA is set to 1 when a SLEEP instruction is executed.
When both SSBY and LSON are cleared to 0 in SYSCR1 and a SLEEP instruction is executed,
sleep mode is entered. Direct transfer to active (high-speed) mode or to subactive mode is also
possible. See section 5.8, Direct Transfer, below for details.
• Clearing by RES pin
When the RES pin is driven low, a transition is made to the reset state and active (medium-
speed) mode is cleared.
5.7.3
Operating Frequency in Active (Medium-Speed) Mode
Operation in active (medium-speed) mode is clocked at the frequency designated by the MA1 and
MA0 bits in SYSCR1.
Rev. 6.00, 08/04, page 134 of 628
, IRQ
or WKP
0
1
, or WKP
to WKP
0
7
0
to WKP
interrupts in standby
7
0
interrupts in watch mode, or any
Advertisement
Table of Contents
