Renesas H8/38024 Hardware Manual page 289

Timer Control/Status Register F (TCSRF)
Bit: 7
OVFH
Initial value:
0
R/(W) *
Read/Write:
Note: * Bits 7, 6, 3, and 2 can only be written with 0, for flag clearing.
TCSRF is an 8-bit read/write register that performs counter clear selection, overflow flag setting,
and compare match flag setting, and controls enabling of overflow interrupt requests.
TCSRF is initialized to H'00 upon reset.
Bit 7—Timer Overflow Flag H (OVFH)
Bit 7 is a status flag indicating that TCFH has overflowed from H'FF to H'00. This flag is set by
hardware and cleared by software. It cannot be set by software.
Bit 7
OVFH Description
0 Clearing condition:
After reading OVFH = 1, cleared by writing 0 to OVFH
1 Setting condition:
Set when TCFH overflows from H'FF to H'00
Bit 6—Compare Match Flag H (CMFH)
Bit 6 is a status flag indicating that TCFH has matched OCRFH. This flag is set by hardware and
cleared by software. It cannot be set by software.
Bit 6
CMFH Description
0 Clearing condition:
After reading CMFH = 1, cleared by writing 0 to CMFH
1 Setting condition:
Set when the TCFH value matches the OCRFH value
6 5
CMFH OVIEH
0 0
R/(W) *
R/W
4 3
CCLRH OVFL
0 0
R/(W) *
R/W
Rev. 6.00, 08/04, page 259 of 628
2 1
CMFL OVIEL
0 0
R/(W) *
R/W
(initial value)
(initial value)
0
CCLRL
0
R/W