Table of Contents
Advertisement
Clock Stop Register 1 (CKSTPR1)
Bit:
7
Initial value:
1
Read/Write:
CKSTPR1 is an 8-bit read/write register that performs module standby mode control for peripheral
modules. Only the bit relating to timer C is described here. For details of the other bits, see the
sections on the relevant modules.
Bit 1—Timer C Module Standby Mode Control (TCCKSTP)
Bit 1 controls setting and clearing of module standby mode for timer C.
TCCKSTP
Description
0
Timer C is set to module standby mode
1
Timer C module standby mode is cleared
9.3.3
Timer Operation
Interval Timer Operation
When bit TMC7 in timer mode register C (TMC) is cleared to 0, timer C functions as an 8-bit
interval timer.
Upon reset, TCC is initialized to H'00 and TMC to H'18, so TCC continues up-counting as an
interval up-counter without halting immediately after a reset. The timer C operating clock is
selected from seven internal clock signals output by prescalers S and W, or an external clock input
at pin TMIC. The selection is made by bits TMC2 to TMC0 in TMC.
TCC up/down-count control can be performed either by software or hardware. The selection is
made by bits TMC6 and TMC5 in TMC.
After the count value in TCC reaches H'FF (H'00), the next clock input causes timer C to overflow
(underflow), setting bit IRRTC in IRR2 to 1. If IENTC = 1 in interrupt enable register 2 (IENR2),
a CPU interrupt is requested.
At overflow (underflow), TCC returns to H'00 (H'FF) and starts counting up (down) again.
During interval timer operation (TMC7 = 0), when a value is set in timer load register C (TLC),
the same value is set in TCC.
Note: For details on interrupts, see section 3.3, Interrupts.
6
5
S32CKSTP ADCKSTP TGCKSTP
1
1
R/W
R/W
4
3
TFCKSTP TCCKSTP TACKSTP
1
1
R/W
R/W
Rev. 6.00, 08/04, page 249 of 628
2
1
1
1
R/W
R/W
(initial value)
0
1
Advertisement
Table of Contents
