8.13
Application Note
8.13.1
The Management of the Un-Use Terminal
If an I/O pin not used by the user system is floating, pull it up or down.
• If an unused pin is an input pin, handle it in one of the following ways:
Pull it up to V
Pull it up to V
Pull it down to V
For a pin also used by the A/D converter, pull it up to AV
• If an unused pin is an output pin, handle it in one of the following ways:
Set the output of the unused pin to high and pull it up to V
Set the output of the unused pin to high and pull it up to V
approximately 100 kΩ.
Set the output of the unused pin to low and pull it down to GND with an external resistor of
approximately 100 kΩ.
Rev. 6.00, 08/04, page 236 of 628
with an on-chip pull-up MOS.
CC
with an external resistor of approximately 100 kΩ.
CC
with an external resistor of approximately 100 kΩ.
SS
.
CC
with an on-chip pull-up MOS.
CC
with an external resistor of
CC