Ip Ospf Transmit-Delay - Allied Telesis x510-28GTX Command Reference Manual

OSPF C
OMMANDS
-
IP OSPF TRANSMIT DELAY

ip ospf transmit-delay

Overview Use this command to set the estimated time it takes to transmit a link-state-update
packet on the VLAN interface.
Use the no variant of this command to return to the default of 1 second.
Syntax ip ospf [<ip-address>] transmit-delay <1-65535>
no ip ospf [<ip-address>] transmit-delay
Default The default interval is 1 second.
Mode Interface Configuration for a VLAN interface.
Usage The transmit delay value adds a specified time to the age field of an update. If the
delay is not added, the time in which the LSA transmits over the link is not
considered. This command is especially useful for low speed links. Add
transmission and propagation delays when setting the transmit delay value.
Example The following example shows setting the OSPF transmit delay time to 3 seconds on
the VLAN interface vlan2.
awplus#
awplus(config)#
awplus(config-if)#
C613-50170-01 Rev B
Parameter Description
<ip-address>
The IP address of the VLAN interface.
<1-65535>
Specifies the time, in seconds, to transmit a link-state update.
configure terminal
interface vlan2
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
ip ospf transmit-delay 3
1020