Admin | Snmp - Comtech EF Data CDM-570A Installation And Operation Manual

7.4.3.2.2

Admin | SNMP

•
Chapter 6. FRONT PANEL OPERATION
•
Sect. 7.3 SNMP INTERFACE
The Administrator must use this page to set and return administration information for the
CDM-570A SNMP (Simple Network Management Protocol) feature.
SNMP
•
Simple Network Management – Use the drop-down list to select as Disabled or
Enabled.
•
Enable Authentication Trap – Use the drop-down list to select as Disabled or Enabled.
•
Trap IP 1 / Trap IP 2 – Assign up to two SNMP Trap IP Addresses.
•
Trap Version – Use the drop-down list to select SNMPv1 or SNMPv2.
•
SNMP Read/Write/Trap Community Strings, SNMP Contact/Name/Location – Create
or edit these alphanumeric text strings as follows:
Setting
Read Community String
Write Community String
Trap Community String
SNMP Contact
SNMP Name
SNMP Location
Click [Submit Admin] to save.
Ethernet-based Remote Product Management
CDM-570A/570AL Satellite Modem with Optional Packet Processor
Figure 7-6. Admin | SNMP Page
Factory Default
public
private
comtech
N/A
N/A
N/A
7–18
Typical Parameters
The Read, Write, and Trap Community Strings
can be any alphanumeric combination with a
maximum length of 4 to 15 characters.
The SNMP Contact, Name, and Location strings
can be any alphanumeric combination with a
maximum length of 0 to 20 characters.
Revision 5
MN-CDM570A