Admin | Snmp - Comtech EF Data CDM-625A Installation And Operation Manual

CDM-625A Advanced Satellite Modem
Ethernet-based Remote Product Management
7.5.4.2.2

Admin | SNMP

•
•
The Administrator must use this page to set and return administration information for the CDM-
625A SNMP (Simple Network Management Protocol) feature.
SNMP
•
Simple Network Management – Use the drop-down list to select as Disabled or Enabled.
•
Enable Authentication Trap – Use the drop-down list to select as Disable or Enable.
• Assign up to two SNMP Trap IP Addresses.
•
Trap Version – Use the drop-down list to select SNMPv1 or SNMPv2.
• SNMP Read/Write/Trap Community Strings, SNMP Contact/Name/Location – Create or
edit these alphanumeric text strings as follows:
Setting
SNMP Read Community String
SNMP Write Community String
SNMP Trap Community String
SNMP Contact
SNMP Name
SNMP Location
Click [Submit Admin] to save these settings.
Chapter 6. FRONT PANEL OPERATION
Sect. 7.3 SNMP INTERFACE
Figure 7-6. Admin | SNMP page
Factory Default
public
private
comtech
N/A
N/A
N/A
Typical Parameters
The Read, Write, and Trap Community Strings
can be any alphanumeric combination with a
maximum length of 4 to 15 characters.
The SNMP Contact, Name, and Location strings
can be any alphanumeric combination with a
maximum length of 0 to 20 characters.
7–17
Revision 0
MN-CDM625A