Configuring A Router Mode Point-To-Point System - Comtech EF Data CDM-570A Installation And Operation Manual

Do these steps to finish:
Step Task
5 From User PC 1:
Ping 172.16.10.1 (CDM-IP 1);
•
Ping 172.16.10.2 (CDM-IP 2);
•
Ping 172.16.10.12 (User PC 2).
•
6 From User PC 2:
Ping 172.16.10.2 (CDM-IP 2);
•
Ping 172.16.10.1 (CDM-IP 1);
•
Ping 172.16.10.11 (User PC 1).
•
Do not enable IF Loopback (or link the Tx to Rx by a BNC cable or satellite link)
on a CDM-IP modem operating in Managed Switch Mode when connected to a
LAN. In this configuration, Managed Switch Mode will resend all Layer 2
broadcast packets and cause a "broadcast storm" on the LAN.
D.2.6

Configuring a Router Mode Point-to-Point System

The procedures outlined in this section result in the configuration shown in Figure D-4.
Optional High Performance Packet Processor
CDM-570L/570AL Satellite Modem with Optional Packet Processor
Figure D-4. Router Mode Point-to-Point System Configuration
D–27
Revision 5
MN-CDM570A