Comtech EF Data CDM-570A Installation And Operation Manual page 660

Step
4 If AUPC mode is selected with the IP, IP-ACM, or V2-
cont ACM mode previously selected,additional choices are
presented:
•
•
•
In all case except MEO (which is a very unusual mode)
the mode is fixed at Normal. Enter the maximum
permitted power increase, between 0.0 and 9.9 dB.
Select an alarm when the max power or minimum
ModCod has been reached, or not at all. The choices
are:
•
•
•
5 (SELECT) CONFIG: RX  FEC
Use the ◄ ► arrow keys to select a parameter. Set the
Rx FEC type as:
•
•
Note that this does not have to match the Tx FEC type.
(SELECT) CONFIG: RX  SYMB
6
Use the ◄ ► and ▲▼arrow keys to enter the desired
receive symbol rate. Note that asymmetric operation is
supported – transmit and receive symbol rates do not
have to be equal.
7 (SELECT) CONFIG: TI 
Use the ◄ ► arrow keys to select a parameter. Press
ENTER to set the mode as V2-ACM.
8 (SELECT) CONFIG: TI  V2-ACM  ACM
Use the ◄ ► arrow keys to select a parameter. Press
ENTER to set the mode as
•
•
•
Adaptive Coding and Modulation (ACM) Option
CDM-570A/570AL Satellite Modem with Optional Packet Processor
Task
Max-Range
Tx-Alarm
DemodUnlock
None
Max Power
Mini Modcod
VF2L (VersaFEC-2 Long)
VF2S (VersaFEC-2 Short) Block
ModCod
Unlock-Action
Target-SNR-Margin
Front Panel VFD Mnemonic
Max-Range
DemodUnlock
Maximum-permitted Power
increase: 3.0dB(◄ ►,ENT)
Tx Alarm: None
MiniModcod
RxFEC: Vit Vit-RS TCM-RS
TPC VF Ull VF2L VF2S Unc
RxSymRate:
00031.204kbps(◄ ►,▲ ▼,ENT)
Data Intf: RS422 IP V.35
RS232 G703 IP-ACM V2-ACM
ACM:ModCod Unlock-Action
Target-SNR-Margin
P–14
Revision 5
Tx-Alarm
(◄ ►)
MaxPower
◄ ►
0065.066ksps
MN-CDM570A