Route Table (Edit)
This section displays and allows you to edit all current Route Table entries. From left to right:
Column
Index
Name
Dest.IP/Mask
Interf.
Next Hop IP
Next Hop
HDLC
Multicast
Options
Header Comp.
Payload Comp.
Ethernet-based Remote Product Management
CDM-570A/570AL Satellite Modem with Optional Packet Processor
Figure 7-20. Configuration | Routing | Routes Page
Description
This is the internal table index that is automatically assigned and cannot be edited.
This label helps to maintain the network. Enter a label string in this text box. The assigned
name must be unique and cannot contain any whitespace.
Enter a Destination IP Address/Mask in the form XXX.XXX.XXX.XXX/YY.
Use the drop-down list to select the Interface as toEth or toSat.
Enter the desired Next Hop IP Address for toEth routes. Note that no Next Hop entry is
needed for toSat routes.
Displays the desired Next Hop HDLC IP Address for traffic to be sent over the satellite,
within the following ranges:
Point-to-Point: No HDLC address
•
Small Network: 0x1 – 0xFE
•
Large Network: 0x1 – 0x7FFE
•
Use the drop-down list to select the Multicast Option as noRouting, ethToSatRouting,
satToEthRouting, or satToEthAndEthToSatRouting.
When the optional Header Compression FAST feature is available, use the drop-down list to
Disable or Enable operations.
When the optional Payload Compression FAST feature is available, use the drop-down list to
Disable or Enable operations.
7–37
Revision 5
MN-CDM570A