Administration > Working Mode - Comtech EF Data CDM-570A Installation And Operation Manual

Selection
SNMP Read Community
SNMP Write Community
SNMP Trap Community
SNMP Trap Destination #1
SNMP Trap Destination # 2
SNMP Trap Version
SNMP Enable Authentication
Trap
SNMP System Contact
SNMP System Name
SNMP System Location
9.3.2.6 Administration > Working Mode
See Appendix D.
1. When you select Hot Key 'C' you are first prompted with:
"Changing Modem working mode requires system Reboot.
Do you want to continue (Y/N)[Enter :No]"
Press Y to continue; otherwise press N, [Enter], or [Esc] to quit and return to
the Administration page.
2. Working Mode is disabled when Brouter Mode VLAN Filtering is enabled. If
you attempt to select this item while configured as such, the following error
message displays:
"Can't change Modem Working Mode when Brouter VLAN Filter is Enabled"
Once you elect to continue with configuration, you are prompted to select the active Working
Mode:
Selection
1 – Router – Small Network
2 – Router – Large Network
3 – Router – Point to Point
4 – Router – Vipersat
5 – Managed Switch
Optional Packet Processor - Serial/Telnet CLI Operation
CDM-570A/570AL Satellite Modem with Optional Packet Processor
Hot Key
R
Select to enter community string (20 characters max).
W
Select to enter community string (20 characters max).
T
Select to enter community string (20 characters max).
D
Select to enter a value for the SNMP Trap Destination #1. Enter the
IP address in aaa.bbb.ccc.ddd format.
2 Select to enter a value for the SNMP Trap Destination #2. Enter the
IP address in aaa.bbb.ccc.ddd format.
V Select to toggle between [SNMPv1] and [SNMPv2].
A
Select to toggle [Enabled] or [Disabled]:
C
Select to enter text.
N
Select to enter text.
O
Select to enter text.
Router uses 1 byte HDLC addresses
Router mode using 2 byte HDLC addresses
Router mode uses 0 HDLC addresses to save satellite bandwidth
Router mode when running in a Vipersat Network
Default operating mode, and operates at 10/100BaseT. In this mode the Packet
Processor will forward both IP and non-IP datagrams over satellite without any
defined routes.
9–16
Description
Description
Revision 5
MN-CDM570A