Comtech EF Data CDM-570A Installation And Operation Manual page 128

To edit the SNMP Trap Read or Write Community strings, use the
select a character to edit. Then, use the ▲▼arrow keys to edit that character. Note that
only the first 20 characters on the bottom line are available.
All printable ASCII characters are available with the exception of the backslash '/'
(ASCII code 92) and tilde '~' (ASCII code 126).
Press ENTER once you compose the string – the modem removes all trailing spaces
from the string upon entry.
(CONFIG: Remote Control) Ethernet: SNMP  Traps 
Version
Trap Version:
SNMPv1
Use the
Press ENTER.
(CONFIG: Remote Control) Ethernet: SNMP  Traps  IP
Addr#1 or Addr#2
Trap IP #X:
000.000.000.000
Where 'X' indicates Trap IP #1 or Trap IP #2: To edit the Trap Destination IP Address,
use the
that digit. Press ENTER.
Front Panel Operation
CDM-570A/570AL Satellite Modem with Optional Packet Processor
SNMPv2 (◄ ►,ENT)
◄ ►
arrow keys to select the SNMP Trap Version as SNMPv1 or SNMPv2.
(◄ ►,▲ ▼)
◄ ►
arrow keys to select a digit, and then use the ▲▼arrow keys to change
If you define both Trap IP Addresses as 000.000.000.000, this
disables the Traps.
6–12
Revision 5
◄ ►
arrow keys to
MN-CDM570A