Administration > Feature Configuration >Radius Configuration - Comtech EF Data CDM-570A Installation And Operation Manual

Selection
LAN-to-LAN Routing
Payload Comp Type
Number of System Flows
RADIUS Configuration
9.3.2.3.1 Administration > Feature Configuration >RADIUS Configuration
Selection
RADIUS Client
Server Password Type
Primary Server IP Address
Secondary Server IP Address
Server Shared Secret
Server Port
Optional Packet Processor - Serial/Telnet CLI Operation
CDM-570A/570AL Satellite Modem with Optional Packet Processor
Hot Key
B Toggle as [Enabled] or [Disabled].
In response to the prompt, "
disable the ICMP redirect Messages. Do you want
to continue (Y/N) [Enter :No]"
Type Y to enable. Otherwise, press [Enter] to maintain this feature as
disabled.
[RO] This feature is fixed, at present, to display ALDC (Adaptive Lossless
Data Compression) as the sole and default payload compression type.
Future firmware versions will allow the use of Hot Key 'A' for toggling
between ALDC and other available compression types.
F
In response to the prompt, "
peer modem's Config. Do you want to continue
(Y/N) [Enter :No]"
Type 'Y' to toggle between 20,000 (CDM-570 Compatibility Mode) or
64,000. Otherwise, press [Enter] to maintain this feature as configured.
Y
Select to enter the RADIUS Configuration.
See Section 9.3.2.3.1.
Figure 9-7. RADIUS Configuration
Hot Key
E Toggle [Enabled] or [Disabled]:
T Toggle to select [PAP] or [CHAP]
1 Select to enter the Primary Server IP Address.
2
Select to enter the Secondary Server IP Address.
C Select to enter the Server Shared Secret.
P Select to enter the Server Port.
9–14
Description
Configuring LAN-to-LAN Routing
System Flows should match with
Description
Revision 5
MN-CDM570A