Odu Select:) Info (Information) - Comtech EF Data CDM-570A Installation And Operation Manual

(ODU CONFIG ► MISC:) XRef (External Reference)
ExternalRef Fault Logic:
Summary No-Summary
Use the ◄ ► arrow keys to select Summary or No-Summary, and then press ENTER.
(ODU CONFIG ► MISC:) Ref-Adjust
Internal Ref Adjustment:
087
Use the ▲▼arrow keys to select an Internal 10MHz Reference setting value from 000 to
255. Press ENTER when done.
(ODU CONFIG ► MISC:) RTC (Real-Time Clock)
Sync ODU RTC to Lcl RTC:
Yes
Use the ◄ ► arrow keys to select Yes to cause the CSAT RTC (Real Time Clock) to
synchronize with the modem RTC, or No. Press ENTER when done.
10.2.1.2.1.1.1.2
INFO: Model Transmitter
Receiver LNA Misc
For read-only information on the ODU as currently configured for operation, use the ◄ ► arrow
keys to select Model, Transmitter, Receiver, LNA, or Misc. Press ENTER when done.
The read-only screen shots that follow depict sample configurations – the actual
values and settings will vary and they are dependent on the ODU configuration in
use. Typical for all nested screens, press ENTER or CLEAR to return to the ODU
SELECT: Info menu.
(ODU SELECT ► INFO): Model
CSAT-5060/010
SERIAL # 00225
This screen shows the model and serial number for the ODU in use.
ODU (Transceiver, BUC, LNB) Operation
CDM-570A/570AL Satellite Modem with Optional Packet Processor
(◄ ►)
The CSAT automatically locks to an external 5 or 10 MHz reference
independent of the state of this selection. This selection determines
whether or not the Summary Fault Relay is activated if the CSAT loses
lock with the external reference.
(▲ ▼,ENT)
The Internal Reference is adjusted in the factory to be very accurate
with the default setting of 087. Use this feature as needed to
compensate for the long-term frequency drift of the oscillator.
No (◄ ►,ENT)

(ODU SELECT:) Info (Information)

(◄ ►)
V2.09
(ENT)
10–14
Revision 5
MN-CDM570A