Kst Select: ► Kst Config:) Receiver - Comtech EF Data CDM-570A Installation And Operation Manual

(KST CONFIG: ► KST TX:) HPA
HPA: State
Use the ◄ ► arrow keys to select State or Fault-Logic, and then press ENTER.
(KST CONFIG: ► KST TX:) HPA ► State
KST HPA State:
On
Use the ◄ ► arrow keys to select On or Off, and then press ENTER.
(KST CONFIG: ► KST TX:) HPA ► Fault-Logic
HPA Fault Logic: Summary
No-Summary
To control whether or not HPA fault will activate the SUMMARY FAULT RELAY, use the
◄ ► arrow keys to select Summary or No-Summary. Press ENTER when done.
10.2.1.2.2.1.1.2
KST RX: Frequency
LNA
KST RX: Frequency
LNB
Use the ◄ ► arrow keys to select Frequency, Atten, or LNA/LNB, and then press ENTER.
(KST CONFIG: ► KST RX:) Frequency
ODU Rx Frequency:
10950.0 MHz (◄ ►,▲ ▼,ENT)
To edit the receive frequency, first use the ◄ ► arrow keys to select a digit, and then use the
▲▼arrow keys to change the value of that digit. Press ENTER when done.
(KST CONFIG: ► KST RX:) Atten (Attenuation)
ODU Rx Attenuation:
15 dB
To edit the receive attenuation, first use the ◄ ► arrow keys to select a digit, and then use
the ▲▼arrow keys to change the value of that digit. Press ENTER when done.
ODU (Transceiver, BUC, LNB) Operation
CDM-570A/570AL Satellite Modem with Optional Packet Processor
Fault-Logic
(◄ ►,ENT)
◄ ►,E
Off (
If the HPA power is Off, it cannot report errors, answer messages,
provide serial numbers, etc.
(◄ ►,ENT)
(KST SELECT: ► KST CONFIG:) Receiver
Atten
(◄ ►,ENT)
Atten
(◄ ►,ENT)
(◄ ►,▲ ▼,ENT)
NT)
(Displayed when ODU is a KST-2000A unit)
(Displayed when ODU is a KST-2000B unit)
10–19
Revision 5
MN-CDM570A