Set Ip Address(Es; Set Route Table Entries - Comtech EF Data CDM-570A Installation And Operation Manual

D.2.6.3 Set IP Address(es)
Do these steps (the applicable CLI "hot key" is shown in brackets [#]):
Step Task
1 From the CLI Main Menu:
Select the Interface Configuration submenu [I].
2 From the Interface Configuration Menu:
Select Ethernet Interface submenu [E].
3 Set Ethernet IP Address [I].
CDM-IP 1 to 172.17.10.1
•
CDM-IP 2 to 172.16.10.1
•
4 Set the Ethernet Subnet Prefix Length [M] to 24.
D.2.6.4 Set Route Table Entries
First, do these steps on CDM-IP 1 (the applicable CLI "hot key" is shown in brackets [#]):
Step Task
1 From the CLI Main Menu:
Select the Route Table [R] submenu.
2 Enter 1 to configure the first route.
3
Enter a suitable name.
4 Set IP Address to 172.16.10.0
5 Set Number of Subnet Bits to 24.
6 For Interface to which route is destined to <E-Ethernet S-Satellite Enter : S> select S.
7 The CDM-IP 1 Route Table should display the following:
Route001...[test
Optional High Performance Packet Processor
CDM-570L/570AL Satellite Modem with Optional Packet Processor
Route Name Dest IP/SNet Bits
172.16.10.0/24
D–29
Next Hop MultiCast
POINT-TO-POINT N/A
Revision 5
State
toSat]
MN-CDM570A