Admin | Snmp; Figure 6-7. Admin | Snmp Page - Comtech EF Data CDM-625 Installation And Operation Manual

CDM-625 Advanced Satellite Modem
Ethernet-based Remote Product Management
6.5.4.2.2

Admin | SNMP

•
•
The Administrator must use this page to set and return administration information for the
CDM-625 SNMP (Simple Network Management Protocol) feature.
SNMP
• Simple Network Management – Use the drop-down list to select as Disabled or Enabled.
•
Enable Authentication Trap – Use the drop-down list to select as Disable or Enable.
•
Assign up to two SNMP Trap IP Addresses.
• Trap Version – Use the drop-down list to select SNMPv1 or SNMPv2.
•
SNMP Read/Write/Trap Community Strings, SNMP Contact/Name/Location – Create or
edit these alphanumeric text strings as follows:
Setting
SNMP Read Community String
SNMP Write Community String
SNMP Trap Community String
SNMP Contact
SNMP Name
SNMP Location
Click [Submit Admin] to save these settings.
Chapter 5. FRONT PANEL OPERATION
Sect. 6.3 SNMP INTERFACE

Figure 6-7. Admin | SNMP page

Factory Default
public
private
comtech
N/A
N/A
N/A
Typical Parameters
The Read, Write, and Trap Community Strings
can be any alphanumeric combination with a
maximum length of 4 to 15 characters.
The SNMP Contact, Name, and Location strings
can be any alphanumeric combination with a
maximum length of 0 to 20 characters.
6–18
Revision 13
MN-CDM625