Satellite Modem > Configuration > Framing Mode Configuration - Comtech EF Data CDM-570A Installation And Operation Manual

9.3.8.1.3 Satellite Modem > Configuration > Framing Mode Configuration
Open the nested Framing Mode Configuration page from the Configuration page.
Selection
Framing Mode
EDMAC Mode
EDMAC Slave Address Range
AUPC
Max Power Reached Action
Remote Demod Unlock Action
Target E /N of Remote Demod
b 0
(db)
Maximum Power Limit
Optional Packet Processor - Serial/Telnet CLI Operation
CDM-570A/570AL Satellite Modem with Optional Packet Processor
Figure 9-32. Framing Mode Configuration
Hot Key
F Select the Framing Mode:
1 – Unframed
2 – EDMAC Framing
3 – EDMAC-2 Framing
D Select the EDMAC Framing Mode:
1 – Unframed
2 – EDMAC Framing
3 – EDMAC-2 Framing
V Set a value from 10 to 9990 in multiples of ten.
A
Select the AUPC operation:
1 – Enable
2 – Disable
R Select the action:
1 – No_Action
2 – Generate_TX_Alarm
U Select the action:
1 – Nominal_Power
2 – Maximum_Power
E
Set a value from 0.0 to 9.9.
M Set a value from 0 to 9.
9–49
Description
MN-CDM570A
Revision 5