Background - Comtech EF Data CDM-570A Installation And Operation Manual

P.2

Background

ACM is not a new concept. It has been used for some time in wireless communications, including
terrestrial microwave applications and, more recently, over satellite links. Its primary function is to
optimize throughput in a wireless data link, by adapting the modulation order used and the Forward
Error Correction code rate – both of which directly affect spectral efficiency (expressed in bits per
second per Hertz) according to the noise conditions (or other impairments) on the link. Implicit in
this concept is that the symbol rate (and power) of the wireless communication system must remain
constant. This ensures that the bandwidth allocated for a particular link is never exceeded.
Given that the symbol rate does not change, if modulation and coding are changed, the data rate
must therefore be modified. This is expressed in the simple equation:
Symbol rate = bit rate / (modulation order * code rate)
For example, for Rate 3/4 QPSK (where modulation order = 2):
Symbol rate = bit rate * 0.666
Re-arranging:
So, in changing to a higher modulation order or code rate, the bit rate is increased, and in
changing to a lower modulation order or code rate, the bit rate is reduced.
However, some important factors must be considered:
•
The digital communications system must be able to tolerate a change in bit rate.
Synchronous serial interfaces (such as G.703 E1, which operated at a fixed data rate of
2.048 Mbps) are totally unsuitable in a scheme where data rate is changing. The only
practical application for this scheme is a packet-based scheme that will tolerate a change
in data rate, and which has mechanisms within its protocols to recognize when increased
or reduced bandwidth is available. The best example of this is Ethernet, and this
discussion is limited to schemes that employ it.
•
The bit rate cannot be changed arbitrarily.
The link noise conditions, described in terms of Eb/No or SNR, must be able to support
reliable communications for the given modulation order and code rate. This is a key point,
as in fact, the link SNR is the input that drives the adaptation.
Adaptive Coding and Modulation (ACM) Option
CDM-570A/570AL Satellite Modem with Optional Packet Processor
Bit rate = symbol rate * modulation order * code rate
P–2
Revision 5
MN-CDM570A