Combined Working Mode - Comtech EF Data CDM-570A Installation And Operation Manual

70/140 mhz/l-band/reduced chassis depth/with optional high performance packet processor
Hide thumbs Also See for CDM-570A:
Table of Contents

Advertisement

Managed Switch Mode also supports VLAN's and when VLAN Mode is enabled, will
forward traffic as follows:
If an untagged packet arrives at the Packet Processor, it will egress as a tagged
o
packet with the defined Native VLAN ID.
VLAN entries can be added into the VLAN Table and to forward VLAN's over the
o
satellite. A VLAN entry is also needed on the receiving CDM-570A to receive the
VLAN traffic and they will egress as tagged VLAN's.
If a tagged packet arrives at the Ethernet port, it will only be forwarded if there is a
o
matching VLAN entry in the VLAN Table and it will egress as tagged. If there is no
matching VLAN in the VLAN Table, the tagged packet will be dropped.
VLAN operation in the CDM-570A/570AL-IP also includes full 802.1Q VLAN QoS
support. With the QoS Option enabled, the Packet Processor will read the 802.1Q VLAN
Priority (7 through 0) that is in the VLAN Header in each VLAN frame received and will
prioritize traffic accordingly.
D.1.2.5.2

Combined Working Mode

In order greatly simply the configuration complexity, the working modes operation of modem have
been centralized in the single Working Mode configuration parameter, which in turn offer the
following functional parameters:
Mode Selection
Managed Switch
Router – Small Network Mode
Router – Large Network Mode
Router – Point to Point
Router – Vipersat
The Vipersat "Unit Role" and "Expansion Role" parameters are not read-only.
Optional High Performance Packet Processor
CDM-570L/570AL Satellite Modem with Optional Packet Processor
Function
Managed switch with support for VLAN as well as advanced features
such as QoS, Header Compression and Payload Compression.
Primarily intended for operation in a point-to-point topology.
Hub side router in a Point-to-Multipoint network. Allows Sat-to-sat.
Remote Router in a Point-to-Multipoint network. Packets from the WAN
are not allowed to be sent to the WAN. No longer requires HDLC
receive addresses to be configured.
Point-to-Point router in Point-to-Point configurations.
Hub router in a Vipersat Network.
D–14
Revision 5
MN-CDM570A

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cdm-570alCdmr-570al

Table of Contents