Satellite Modem > Configuration > Alarm Mask Configuration - Comtech EF Data CDM-570A Installation And Operation Manual

Selection
Frequency Reference
Test Mode
9.3.8.1.6 Satellite Modem > Configuration > Alarm Mask Configuration
Open the nested Alarm Mask Configuration page from the Configuration page.
Selection
Tx FIFO
G.703 BPV
Tx AIS
RX AGC
E /N
b 0
Rx AIS
Buffer Slip
External Reference
BUC
LNB
Optional Packet Processor - Serial/Telnet CLI Operation
CDM-570A/570AL Satellite Modem with Optional Packet Processor
Hot Key
R Select the Frequency Reference:
1 – Internal 10 MHz
2 – External 1 MHz
3 – External 2 MHz
4 – External 5 MHz
5 – External 10 MHz
6 – Internal Plus Output
T Select the Test Mode:
1 – Normal
2 – IF_loopback
3 – Digital_loopback
4 – I/O_Loopback
5 – RF Loopback
6 – Tx_CW
7 – TX_alt_101010
Figure 9-35. Alarm Mask Configuration
Hot Key
A
Toggle to set alarm masking as Masked or Unmasked.
B
NOTE: These settings should always be set as Masked when IP is the
C
active data interface.
D
E
Toggle to set alarm masking as Masked or Unmasked.
F
G Toggle to set alarm masking as Masked or Unmasked.
NOTE: This setting should always be set as Masked when IP is the
active data interface.
H
I Toggle to set alarm masking as Masked or Unmasked.
J
9–51
Description
Description
MN-CDM570A
Revision 5