Comtech EF Data CDM-570A Installation And Operation Manual page 317

Command
Parameter (Instruction
Type Code and
Qualifier)
Faults and N/A 6 bytes
Status
Serial-based Remote Product Management
Arguments for
Command or
Response to
Query
Query only.
Returns the current highest-priority fault and status codes for the Unit
(hardware), Tx Traffic, Rx Traffic and ODU in the form abcdef, where:
a = Unit faults:
0 = No faults
1 = Power supply fault, +5 volts
2 = Power supply fault , +12 volts
3 = Power supply fault, –5 volts
4 = Reserved
5 = Power supply fault, –12 volts
6 = Tx synthesizer lock
7 = Rx 1st LO synthesizer lock
8 = Rx 2 LO synthesizer Lock
nd
9 = Ref PLL lock
A = Reserved
B = Reserved
C = Reserved
D = Reserved
E = Packet Processor
F = Reserved
b = Tx Traffic status:
0 = Tx traffic OK
1 = No clock from terrestrial interface
2 = Tx PaP ETH Link Down
3 = Tx FIFO slip
4 = G.703 Loss of Signal (valid only in Clock Extend Mode)
5 = Loss of External Reference
6 = Reserved
7 = AUPC upper limit reached
8 = Reserved
9 = AIS detected on incoming data
A = Reserved
B = Bipolar violation on G.703 interface
C = Reserved
D = Reserved
E = Reserved
F = BUC Alarm (if attached)
CDM-570A/570AL Satellite Modem with Optional Packet Processor
Description of Arguments
8–51
Revision 5
Query
Response to
(Instruction Code
Command
and Qualifier)
N/A FLT? FLT=abcdef
Arguments)
MN-CDM570A
Response to
Query
(see Description of